If you recall, this car fired (and actually drove) earlier this year. However, the oil pan had a stripped plug and the exhaust manifold was so warped you could see fire through the gap between it an the head. Also the carb was leaking gas right above said exhaust manifold. It was cheaper to find a whole new setup than replace the individual parts. So after re-assembling the head, rebuilding the carb, replacing the fuel pump and starter and doing a bit of tuning, it fires right up. That burble is courtesy of about 18 inches of leftover exhaust pipe.
Funny story: when cranking endlessly to get the thing to start, we noticed the throttle rod linkage was sparking and getting hot. WTF? Turns out in re-EVERYTHING-ing, we forgot to hook up an engine-to-chassis ground. With no driveshaft in place, there’s nothing but rubber mounts between the starter and chassis ground. Well, nothing but the throttle linkage. Thus, we were pumping a couple hundred amps through a series of clipped-together metal bits.
But hey, it runs (idles and revs) with no major issues.
With that out of the way, the to-do list as of tonight is…